|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This is an excellent handbook. We had no information on the appliance until we obtained this and are now able to use the appliance to its full potential. Strongly recommended.
;
Very happy to find this from owners-manual.com and the enclosed spec sheet as well.
Not longer available from Sony.
;
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
;
Perfect. Very good service and very good scanning quality. All sheets are very legible. Thank's
;
My first manual from Owner-Manuals.com but not the last! I am very satisfied with the easy ordering and promt delivery of a manual I did not find anywhere else.
three. Operation
Mode Off On Standby Procedure Receiver/amplifier off Receiver/amplifier on and playing program material Simply turn off your receiver/amplifier. The subwoofer will turn off after approximately five minutes. The subwoofer will turn on when your receiver/amplifier begins playing again. LED Status Red Green Red
Volume
min max Volume
min max Volume
Crossover Frequency
The crossover-frequency knob determines the highest frequency your subwoofer will reproduce. It allows a seamless transition from the subwoofer to the satellite speakers. Experiment with this adjustment to find the crossover frequency that sounds best with your speakers. When the control is at the �50� position, very few high frequencies will be heard. This position is best suited to large main speakers. For most users, the control should be set somewhere near the mid position. For listeners using very small speakers, best results will be obtained with the control at the �150� position.
Troubleshooting
If you used the high-level (SPKR) inputs and there is no sound from any of the speakers, check the following: � Receiver/amplifier is on and a source is playing. � Powered subwoofer is plugged in. � Check all wires and connections between receiver/ amplifier and speakers. Make sure all wires are connected. Make sure none of the speaker wires are frayed, cut or punctured. � Review proper operation of your receiver/amplifier. If there is low bass output, check the following: � Make sure the connections to the left and right �Speaker Inputs� have the correct polarity (+ and �). � Make sure that the subwoofer is plugged into an active electrical outlet. � Powered subwoofer is plugged in. � Adjust the crossover point. If you used the line-level inputs and there is no sound from the subwoofer, check the following: � Receiver/amplifier is on and a source is playing. � Powered subwoofer is plugged in. � Check all wires and connections between receiver/ amplifier and subwoofer. Make sure all wires are connected. Make sure none of the wires are frayed, cut or punctured. � Review proper operation of your receiver/amplifier.
|
|
|
> |
|
